Weider 4990 I Uk Manual - Page 13
Cable Guides 52 are holding the Arm Cable
View all Weider 4990 I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
15. See the CABLE DIAGRAM on page 27 and identify the Arm Cable (51). Apply grease to an M10 x 32mm Bolt (59). Attach one end of the Arm Cable (51) to the Right Arm (13) with the M10 x 32mm Bolt (59), an M10 Washer (73), and an M10 Locknut (68). Do not overtighten the Locknut; the end of the Arm Cable must pivot easily. 15 59 Grease 51 13 73 68 16. Route the Arm Cable (51) over a Pulley (42). Attach the Pulley (42) and two Cable Guides (52) to the right U-bracket (22) on the Upright (5) with an M10 x 50mm Bolt (58), two M10 Washers (73), and an M10 Locknut (68). Make sure that the Cable Guides are oriented as shown. See the inset drawing. Make sure that the Cable Guides (52) are holding the Arm Cable (51) in the groove of the Pulley (42). 16 68 52 22 73 51 42 58 52 52 5 51 42 52 17. Route the Arm Cable (51) under a Pulley (42). 17 Attach the Pulley (42) and two Cable Guides (52) to one end of the Offset Double U-bracket (85) with an M10 x 50mm Bolt (58), two M10 Washers (73), and an M10 Locknut (68). Make sure that the Cable Guides (52) are holding the Arm Cable (51) in the groove of the Pulley (42). 42 52 58 73 51 52 68 73 85 13