Weider Club 16.6st English Manual - Page 12
Cable Assembly
View all Weider Club 16.6st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
20. Wrap the High Cable (58) around a "V"-Pulley 20 (50). Attach the Pulley and a Long Cable Trap (31) to the indicated bracket on the Front Upright (42) with an M10 x 55mm Bolt (86) and an M10 Nylon Locknut (21). Be sure that the Long Cable Trap is positioned to hold the Cable in place. 21. Route the High Cable (58) around the "V"Pulley (50) on the Left Arm (47). Be sure that 21 the Cable is in the groove of the Pulley and that the Long Cable Trap (31) is posi- tioned to hold the Cable in place. Tighten the M10 x 55mm Bolt (86) and the M10 Nylon Locknut (not shown). 86 31 58 50 Bracket 42 21 50 86 31 58 47 22. Route the High Cable (58) around the "V"- 22 Pulley (50) on the Right Arm (48). Be sure that the Cable is in the groove of the Pulley and that the Long Cable Trap (31) is turned to hold the Cable in place. Tighten the M10 x 55mm Bolt (86) and the M10 Nylon Locknut (not shown). 31 86 50 58 48 CABLE ASSEMBLY 23. Attach the Pulley Bracket (20) to the Top 23 Frame (55) with the M8 x 120mm Bolt (68) 68 and an M8 Nylon Locknut (3). Do not over- tighten the Nylon Locknut; the Pulley Bracket must be able to move freely. See the inset drawing. Route the High Cable 55 66 (58) around the 90mm Pulley (15) attached to the Pulley Bracket (20). Tighten the M10 x 20 12 50mm Bolt (12) and an M10 Nylon Locknut (not shown). Be sure that the Cable is in the groove of the Pulley and that the Cable 3 15 58 Trap (66) is turned to hold the Cable in place. 12