Weider Club 16.6st English Manual - Page 14
mm Bolt 88 and an M10 Nylon Locknut - locations
View all Weider Club 16.6st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
CABLE ASSEMBLY 27. Locate the Low Cable (23). Route the Low 27 Cable under a 90mm Pulley (15). Attach the Pulley to the M10 x 95mm Bolt (not shown) in the Press Frame (17) with an M10 Nylon Locknut (21). Be sure that the end of the Cable with the ball is on the indicated side of the Press Frame and that the Cable is between the Pulley and the crossbar on the Press Frame. Crossbar 21 15 23 Ball 17 28. Remove the 90mm Pulley (15) from the lower hole in the Front Upright (42). Wrap the Low Cable (23) around the Pulley and reattach the Pulley to the Front Upright (42) with an M10 x 95mm Bolt (88) and an M10 Nylon Locknut (21). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. 28 21 42 15 23 23 15 88 66 42 Inset shows view from other side 29. Route the Low Cable (23) around the 90mm Pulley (15) attached to the upper hole in the 29 Press Frame (17). Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the M10 Nylon Locknut (21) and the M10 x 85mm Bolt (not shown). 23 15 21 66 17 30. Remove the indicated 90mm Pulley (15) from the Front Upright (42). Wrap the Low Cable 30 (23) around the Pulley and reattach the Pulley and Cable Trap (66) to the upper hole in the 23 Front Upright with an M10 x 95mm Bolt (88) and an M10 Nylon Locknut (21). See the 42 15 inset drawing. Be sure that the Cable Trap 21 is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. 15 88 23 66 42 Inset shows view from other side 14