Weider Club 16.6st English Manual - Page 9
Arm Assembly
View all Weider Club 16.6st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ARM ASSEMBLY 12. Press a 25mm Round Inner Cap (49) into one of the Press Arms (46). Press a 45mm Square Inner Cap (44) into the Press Arm. Attach the Press Arm (46) to one side of the Press Frame (17) with two M8 x 60mm Bolts (22) and two M8 Nylon Locknuts (3). Assemble the other Press Arm (46) in the same manner. 13. Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket on each Arm. Arm identification is very important for step 14. Press a 70mm Plastic Bushing (89) into the Right Arm (48). Attach a "V"-Pulley (50) and a Long Cable Trap (31) to the Right Arm with an M10 x 55mm Bolt (86) and an M10 Nylon Locknut (21). Do not tighten the Locknut yet. Assemble the Left Arm (47) in the same manner. 14. Lubricate both axles on the Top Frame (55). Slide the Right Arm (48) onto the right axle. Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 13 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55). Tap two 25mm Retainers (69) and a 25mm Round Cover Cap (70) onto the axle. Be sure that the teeth on the Retainers bend toward the Round Cover Cap, as shown in the inset drawing. Attach the Left Arm (47) in the same manner. Press 45mm Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a Large Foam Pad (45) onto the lower end of each Arm. 12 44 49 46 22 46 13 86 31 50 89 3 17 47 21 Welded Brackets 48 14 48 55 Bracket 47 Lubricate Axle 69 45 70 44 44 Axle 45 69 70 9