Weider Club 16.6st English Manual - Page 18
Bolt 88, an M10 Washer 9, and an M10
View all Weider Club 16.6st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
CABLE ASSEMBLY 38. Locate the Leg Press Cable (99). Attach the 38 end of the Leg Press Cable to the Long "U"- Bracket (57) with an M8 Nylon Locknut (3) and an M8 Washer (8). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing. Wrap the Leg Press Cable (99) around a 90mm Pulley (15). Attach the Pulley to the Leg Press Upright (56) with the M10 x 95mm Bolt (88), an M10 Washer (9), and an M10 Nylon Locknut (21). The ball on the Cable must be on the indicated side of the Pulley. Be sure that the Cable and Pulley move smoothly and that the Cable is between the Pulley and the welded rod. 3 8 57 99 88 15 39. Attach the Press Bracket (94) to the Leg Press Arm (96) with an M10 x 75mm Bolt (111) and an M10 Nylon Locknut (21). Wrap the Leg Press Cable (99) around a 90mm Pulley (15). Attach the Pulley to the Press Bracket (94) with the M10 x 50mm Bolt (12) and an M10 Nylon Locknut (21). Slide an M8 Washer (8) onto an M8 x 75mm Bolt (93). Insert the Bolt through the lowest hole in the Rear Seat Frame (100) from the indicated side. Note: The three holes are for cable adjustment. Tighten an M8 Nylon Locknut (3) onto the Bolt. Slide the end of the Leg Press Cable (99) onto the end of the Bolt. Thread another M8 Nylon Locknut onto the Bolt. Do not fully tighten the second Locknut. There must be room between the two bolts for the end of the Cable to pivot. Welded 3 Rod 8 99 57 39 93 8 96 12 21 94 99 15 21 100 3 56 Ball 9 21 111 18