Weider Club 16.6st English Manual - Page 17
Cable Trap 66 to the Pivot Arm 101
View all Weider Club 16.6st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
36. Slide an M8 Washer (8) onto an M8 x 75mm Bolt (93). Insert the Bolt through the indicated hole in the Pivot Arm (101). The Bolt must be inserted from the side shown. Fully tighten an M8 Nylon Locknut (3) onto the Bolt. Wrap the Military Press Cable (72) around a 90mm Pulley (15). Attach the Pulley and a Cable Trap (66) to the Pivot Arm (101) with the M10 x 95mm Bolt (88), an M10 Washer (9), and an M10 Nylon Locknut (21). Be sure that the Pulley is on the side shown and that the Cable Trap is positioned to hold the Cable in place. 36 21 3 9 101 72 15 8 93 66 88 CABLE ASSEMBLY 37. See inset drawing A. Attach a 90mm Pulley (15) and a Cable Trap (66) to the upper hole in a Long "U"-Bracket (57) with an M10 x 50mm Bolt (12) and an M10 Nylon Locknut (21). Be sure that the Cable Trap is inside the Long "U"-Bracket. Note: This may come pre-assembled. Route the Military Press Cable (72) through the Long "U"-Bracket (57) and around the 90mm Pulley (15). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly. See inset drawing B. Slide the end of the Military Press Cable (72) onto the end of the indicated M8 x 75mm Bolt (93). Thread another M8 Nylon Locknut (3) onto the Bolt. Do not fully tighten the second Locknut. There must be room between the two Locknuts for the end of the Cable to pivot. 37 15 57 72 21 57 3 72 93 15 A 66 12 B 17