Weider Club 16.6st English Manual - Page 13

CABLE ASSEMBLY 24. See the inset drawing. Attach a 90mm Pulley (15) and a Cable Trap (66) to the upper hole in a Long "U"-Bracket (57) with an M10 x 50mm Bolt (12) and an M10 Nylon Locknut (21). Be sure that the Cable Trap is inside the Long "U"-Bracket. Note: This may come preassembled. Route the High Cable (58) through the Long "U"-Bracket (57) and around the 90mm Pulley (15) shown in the inset drawing. Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly. 24 66 21 57 25. Wrap the High Cable (58) around a 90mm Pulley (15). Attach the Pulley to the bracket on the Top Frame (55) with an M10 x 50mm Bolt (12) and an M10 Nylon Locknut (21). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly. 25 55 58 15 12 57 58 Bracket 15 58 12 15 21 26. Note: This assembly step shows how to 26 complete the assembly of several pre- attached parts. The 15mm Spacer (7) has been pre-attached ton the Press Frame (17) for shipping purposes. Remove the M10 Nylon Locknut (21), the Spacer, and the 90mm Pulley (15) from the M10 x 95mm Bolt (88). Do not remove the Bolt; the Bolt has been shown removed for part identification. Slide the 15mm Spacer (7) back onto the M10 x 95mm Bolt (88). 9 88 7 17 15 21 13