Xerox C2424 User Guide Section 5: Printing - Page 45
Printing Xerox Carbonless Paper from Tray 2, 3, or 4
![]() |
UPC - 095205676532
View all Xerox C2424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Specialty Paper 5. On the control panel: a. Select Change, then press the Enter button. b. Select the paper size, then press the Enter button. c. Select Special for paper type, then press the Enter button to save your selection. 6. In the printer driver, select Tray 1 as the paper source. Note Do not select Proof Prints during the print job. It will disturb the sequence of the pre-collated sets. 7. To ensure the carbonless paper sets are properly loaded in the tray: a. Print one complete set. b. Remove the set from the output tray. c. Mark the top, white sheet of the printed set with a pen or a pencil. ■ If the paper is loaded correctly, the mark should appear on the printed side of the subsequent colored sheets within a few seconds. ■ If a mark does not appear, repeat Steps 1-7 to make sure the paper is loaded correctly. Printing Xerox Carbonless Paper from Tray 2, 3, or 4 1. Pull the tray completely out of the system. 2424-001 WorkCentre® C2424 Copier-Printer 5-45
![](/manual_guide/products/xerox-c2424-user-guide-section-5-printing-f8261fe/45.png)