Xerox Z750/N Network Guide - Page 16
Running the config-IP script, config-IP
UPC - 042215455084
View all Xerox Z750/N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Setting IP addressing: PostScript utility file (UNIX only) Running the config-IP script 1. Connect the printer to a network. ARP (Address Resolution Protocol) requires that the printer be connected on the same physical network segment as the host. 2. Run the script config-IP: a. In the directory where you placed your printer's network utilities, change (cd) to the bin subdirectory. b. Type the name of the script, redirecting the output to a file. Type: config-IP > filename 3. Enter the information when prompted by the script. Note The script accepts IP addresses that have empty fields (for example, 123..40.10). The script does not detect this error. Double-check the IP addresses you enter. 4. Log in as root. 5. Make an entry into the host's ARP table defining the printer's IP/hardware address pair. In general, this requires a command corresponding to one of the following examples: arp -s printer-IP-address hardware-address (for BSD systems) or arp -s ether printer-IP-address hardware-address (for System V) See your host system documentation for specifics of this command. Note The hardware address in the arp command example is the printer's Ethernet Address for PhaserShare Ethernet interfaces or the Token Ring Address for PhaserShare Token Ring cards. 6. Turn on the printer. 7. Execute the ping command from the host: ping printer-IP-address 8. Use the host spooling system (for example, lpr or lp) to send to the printer the file you created in Step 2b. This stores the IP addressing information in the printer's internal memory, where it is retained over a reset or power cycle. (For more information on setting up queues, see TCP/IP Host Configuration (UNIX) on page 25.) 9. Reset the printer. PhaserShare Networking Manual 11