Yamaha AW4416 Owner's Manual - Page 147
Patching to the recorder inputs
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Chapter8-Patching Patching to the recorder inputs When the AW4416 is in the default state, buses 1-8 are assigned respectively to recorder inputs 1-8 and 9-16, but you can assign the direct signals from the input channels as desired. Mixer section Buses 1-8 Recorder input patch Recorder section ×8 Tracks 1-8 ×8 Tracks 9-16 Here's how to assign the desired signals to recorder inputs 1-16. 1. Press the [SETUP] key ¡ [F1] (Patch IN) key to access the SETUP screen Patch IN page. The RECORDER TRACK INPUT ASSIGN column will indicate the patched status of recorder inputs 1-16. Tip! If the Patch IN tab is not assigned to the [F1] key, press the [SHIFT] key + [F1] key to switch the tabs, and then press the [F1] key. RECORDER TRACK INPUT ASSIGN column 2. Move the cursor to the recorder input whose patching you wish to change, and use the [DATA/JOG] dial to select the signal that you wish to assign. The following types of signal can be assigned to each input. ❍ Recorder inputs 1-16 Display BUS 1 - BUS 8 DIR 1 - DIR16 Type of signal Buses 1-8 Input channel direct out 1-16 135 - Operation Guide