Yamaha DTX402K DTX402K/DTX432K/DTX452K Owners Manual - Page 51

Setting Parameters using Menu Mode Advanced Techniques 5-2. Crosstalk Steps: Hold down the Mode switch  [5]  [2]  Setting Setting 5-3. Snare Pad Type Steps: Hold down the Mode switch  [5]  [3]  Setting Setting The term "crosstalk" refers to the output of spurious trigger signals from a pad other than the one that was stuck as a result of vibration or interference between pads. You can adjust the Crosstalk parameter for individual pads to prevent this phenomenon from occurring. 1. Hold down the Mode switch to activate Menu Mode. 2. Press number button [5] to select the Trigger Settings parameter group. 3. Press number button [2] to select the Crosstalk param- eter. 4. Strike a pad to select it. 5. Enter a new setting (%) using the TEMPO[+]/[-] but- tons. Larger values are more effective in preventing crosstalk; however, they can also make it difficult to play pads simultaneously during light drumming. Setting 0 to 99 You can specify the type of snare pad connected to your drum module. 1. Hold down the Mode switch to activate Menu Mode. 2. Press number button [5] to select the Trigger Settings parameter group. 3. Press number button [3] to select the Snare Pad Type parameter. 4. Select a new snare pad type using the corresponding number button [1] to [6]. Number button [1] [2] [3] [4] [5] [6] Setting Automatic identification (only for [2] and [3]) TP70S Snare pad that comes with DX402K/ DTX432K XP-series pad TP70S reversed XP-series pad reversed NOTE • When set to [1], the drum module will automatically identify the type of snare pad that came with your electronic drum kit when it is turned on. If you then press and hold number button [1], the drum module will flash number button [2] or [3] to indicate the result of automatic identification. • Whenever you change the type of snare connected to the drum module, please update this setting using the corresponding number button [2] to [4]. For example, when you use the XPseries pad, select [4]. • You can use setting [5] or [6] to switch (or reverse) the drum sounds assigned to Rim 1 and Rim 2. This makes it easier for left-handed drummers to configure their electronic drum kit. DTX402K DTX432K DTX452K Owner's Manual 49