Yamaha HTR 5860 MCXSP10 Manual - Page 26
Connecting the power supply cord, Speaker impedance setting, Connecting the AC power cord
UPC - 027108922096
View all Yamaha HTR 5860 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
CONNECTIONS Connecting the power supply cord Speaker impedance setting ■ Connecting the AC power cord Plug the power cord into an AC wall outlet. ■ AC OUTLET(S) (SWITCHED).....2 outlets Use these outlets to connect the power cords from your other components to this unit. Power to the AC OUTLET(S) is controlled by this unit's STANDBY/ON (or SYSTEM POWER and STANDBY). The outlet(s) supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is 100 W. ■ Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However if the power cord is disconnected from the AC wall outlet, or the power supply is cut for more than one week, the stored data will be lost. CAUTION If you are using 4 or 6 ohm speakers, set the impedance to 4 or 6 ohms as follows before turning on the power. Be sure this unit is in the standby mode. 1 Turn off the power to this unit, and while holding down STRAIGHT (EFFECT), press STANDBY/ON. This unit turns on, and "SP IMP." appears in the front panel display. STRAIGHT EFFECT While holding down, press STANDBY /ON SP IMP. 2 Press STRAIGHT (EFFECT) repeatedly to select "4 Ω MIN". STRAIGHT EFFECT 3 Press STANDBY/ON to turn off the power. STANDBY /ON The setting you made is reflected the next time this unit's power is turned on. 22