Yamaha HTR-6180BL Owner's Manual - Page 32
Connecting the power cable, Setting the speaker impedance, AC OUTLETS SWITCHED
UPC - 027108930107
View all Yamaha HTR-6180BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Connections Connecting the power cable Setting the speaker impedance (U.S.A. model) MONITOR OUT AC OUTLETS SWITCHED 120V 80Hz 100W MAX. TOTAL 0.8A MAX. TOTAL C DVR To the AC wall outlet Caution If you are to use 6 ohm speakers, set "SP IMP." to "6Ω MIN" as follows BEFORE using this unit. 4 ohm speakers can be also used as the front speakers. 1 Press LSYSTEM OFF on the front panel to turn off this unit. See page 29 for details. 2 Press and hold MTONE CONTROL and then press KMAIN ZONE ON/OFF to turn on this unit. This unit turns on, and the advanced setup menu appears in the front panel display. ■ AC OUTLETS (SWITCHED) Use these 2 outlets to supply power to any connected components. Connect the power cable of your other components to these 2 outlets. Power to these 2 outlets is supplied when this unit is turned on. However, power to these 2 outlets is cut off when this unit is turned off. For information on the maximum power or the total power consumption of the components that can be connected to these 2 outlets, see "Specifications" on page 127. Note The power to AC OUTLETS of this unit is not cut off while this unit is charging connected iPod even when this unit is in the standby mode. When this unit completes charging or the iPod is disconnected, the power is cut off automatically when this unit is in the standby mode. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However, the stored data will be lost in case the power cable is disconnected from the AC wall outlet or if the power supply is cut off for more than one week. TONE CONTROL While holding down MAIN ZONE ON/OFF 3 Rotate the NPROGRAM selector to select "SP IMP.". "SP IMP." and the current speaker impedance setting ("8Ω MIN") appear in the front panel display. 4 Press MTONE CONTROL repeatedly to select "6Ω MIN". 5 Press LSYSTEM OFF to save the new setting and turn off this unit. Note The setting you made is reflected next time you turn on this unit. 28 En