Yamaha HTR-6180BL Owner's Manual - Page 40
If an error screen appears, If WARNING appears, WARNING and then press
UPC - 027108930107
View all Yamaha HTR-6180BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
p [ [ p Optimizing the speaker setting for your listening room (YPAO) 15 Press 8ENTER to confirm your selection. The top "SET MENU" screen appears in the OSD. SET MENU . ;AUTO SETUP ;MANUAL SETUP .A;SIGNAL INFO [ ]/[ ]:Up/Down [ENTER]:Enter 16 Press ISET MENU to exit from "SET MENU". y If you change speakers, speaker positions, or the layout of your listening environment, run "AUTO SETUP" again to recalibrate your system. ■ If an error screen appears Press 8k / n / l / h to select "RETRY" or "EXIT" and then press 8ENTER. The following display is an example when "E-9:USER CANCEL" appears in the OSD. ERROR . E-9:USER CANCEL Don't operate any function >RETRY EXIT [ ]/[[]:Select [ENTER]:Enter Choices: RETRY, EXIT • Select "RETRY" to retry the "AUTO SETUP" procedure. • Select "EXIT" to exit from the "AUTO SETUP" procedure. y If "E-5:NOISY" appears, "PROCEED" also appears in the choices. When you select "PROCEED", this unit continues the measurements and settings, but the settings may not be optimal. ■ If "WARNING" appears When this unit detects potential problems during the "AUTO SETUP" procedure, "WARNING" appears in the top result display. Check the warning messages to correct your speaker settings. Note Warnings differ from errors in that warnings do not cancel the "AUTO SETUP" procedure. 1 Make sure the pointer is pointing at "WARNING" and then press 8ENTER to display the detailed information about the warning. The number on the right of "WARNING" indicates the number of warning messages. AUTO SETUP . WARNING(3) RESULT SP : 3/4/0.1 DIST: 14.0/17.0ft LVL : -9.0/+6.5dB >SET CANCEL [ ]/[ ]:Up/Down [ENTER]:Detail 2 Press 8l / h repeatedly to toggle between the warning displays. WARNING W-1:OUT OF PHASE Reverse Channel FL -- CENTER PL PR SL SR SBL SBR [ ]/[[]:Select [ENTER]:Return y • For details about each warning message, see the "AUTO SETUP" section in "Troubleshooting" on page 120. • When the corresponding warning message is not applicable to a speaker, "--" is displayed instead. • If "SWFR: TOO LOUD" or "SWFR: TOO LOW" appears in the "W-3: LEVEL ERROR" display, adjust the volume level of the subwoofer(s). 3 Press 8ENTER to return to the top result display. 36 En