Yamaha S08 Owner's Manual - Page 47

Basics Section Effects in Voice Mode In the Voice mode, you can set the Effect Send parameter for the Reverb and Chorus sections, and store them with each Voice. For the Variation Effect, the Effect Type and the various effect parameters can be set, as well as the effect on/off setting for each Voice. The signals that are processed by the Variation block are mixed and sent to the Reverb and Chorus sections. Voice Variation Effect Output System Effects Chorus Voice VOICE Total Lvl Variation (Var) Reverb Send (Fixed setting: Hall 1) Reverb (Rev) Dry/Wet SndCho→Rev Out Total Vol Chorus (Cho) Chorus Send (Fixed setting: Chorus 1) * Depending on the selected effect type, the Dry/Wet parameter may not be available. For details, refer to the Effect Parameter List in the separate Data List booklet. Quick Guide Reference Appendix Reverb n Drum Voices in Voice mode have no Variation effect. n System effects can be bypassed in theVoice mode (UTILITY PAGE14) Effects in Multi Mode You can set the desired Effect type for each Effect section as well as its parameter values for each Multi in the Multi mode. By using Variation as an Insertion effect, you can apply the effect to only one of the Parts (see illustration below). As shown in the illustration below, the Reverb section and Chorus section function as System effects, which process all of the Parts, according to each Part's effect send setting and the global effect return setting - just like on an actual mixer. When using Variation as an Insertion effect, the signal connection is serial, and the effect is applied only to the selected Part - just like patching in an outboard effect on a single instrument channel. Mixer System Effects Reverb Effect Chorus Effect Insertion Effect 123456 16 Part 1~16 Variation Effect Can be used as either System or Insertion effect. Multi Var Connect=INS Part 3 Var Send set to on Part 1 Part 2 Part 3 Variation (Var) Dry/Wet Rev Return Reverb (Rev) SndCho→Rev Out Total Vol Chorus (Cho) Cho Return Part 16 Reverb Send Chorus Send * Depending on the selected effect type, the Dry/Wet parameter may not be available. For details, refer to the Effect Parameter List in the separate Data List booklet. Var Connect set to SYS Dry Level Part 1 Part 2 Part 16 Reverb Chorus Var Send Send Send Reverb (Rev) SndCho→Rev Chorus (Cho) SndVar→Rev Sndvar→Cho Variation (Var) Rev Return Cho Return Var Return Out Total Vol * The default value of Dry Level is 127. This cannot be set from the panel of the S08; however, it can be set by transmitting appropriate MIDI messages from an external device. Effects 47