Yamaha S08 Owner's Manual - Page 74

Appendix Reference Quick Guide Basics Section Release Time (Control #072) Messages which adjust the AEG release time set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Attack Time (Control #073) Messages which adjust the AEG attack time set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Brightness (Control #074) Messages which adjust the filter cutoff frequency set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Lower values will result in a softer sound. Depending on the voice, the effective range may be narrower than the range available for adjustment. Decay Time (Control #075) Messages which adjust the AEG decay time set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Vibrato Rate (Control #076) Messages which adjust the vibrato rate set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Vibrato Depth (Control #077) Messages which adjust the vibrato depth set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Vibrato Delay Time (Control #078) Messages which adjust the vibrato delay time set for each Part. The value set here is an offset value which will be added to or subtracted from the voice data. Portamento Control (Control #084) Messages which apply a portamento between the currently-sounding note and the subsequent note. Portamento Control is transmitted specifying the note-on key of the currently-sounding note. Specify a Portamento Source Key number between 0 - 127. When a Portamento Control message is received, the currently sounding pitch will change with a Portamento Time of 0 to the next note-on key on the same channel. For example, the following settings would apply a portamento from note C3 to C4. 90H 3CH 7FH ......... C3 Note on B0H 54H 3CH ......... Source key number set to C3 90H 48H 7FH.......... C4 Note on (When C4 is on, C3 is raised by a portamento to C4.) Effect1 Depth (Reverb Send Level) (Control #091) Messages which adjust the send level for the Reverb effect. 74 About MIDI Effect3 Depth (Chorus Send Level) (Control #093) Messages which adjust the send level for the Chorus effect. Effect4 Depth (Variation Effect Send Level) (Control #094) Messages which adjust the send level for the Variation effect. If Variation effect uses System effect, this message sets the send level for the Variation effect. If it uses Insertion effect, this setting is invalid. Data Increment (Control #096) Decrement (Control #097) for RPN Messages which increase or decrease the MSB value of pitch bend sensitivity, fine tune, or coarse tune in steps of 1. You are required to assign one of those parameters using the RPN in the external device in advance. The data byte is ignored. When the maximum value or minimum value is reached, the value will not be incremented or decremented further. (Incrementing the fine tune will not cause the coarse tune to be incremented.) NRPN (Non-Registered Parameter Number) LSB (Control #098) NRPN (Non-Registered Parameter Number) MSB (Control #099) Messages which adjust a voice's vibrato, filter, EG, drum setup or other parameter settings. First send the NRPN MSB and NRPN LSB to specify the parameter which is to be controlled. Then use Data Entry (page 73) to set the value of the specified parameter. Note that once the NRPN has been set for a channel, subsequent data entry will be recognized as the same NRPN's value change. Therefore, after you use the NRPN, you should set a Null (7FH, 7FH) value to avoid an unexpected result. The following NRPN numbers can be received. NRPN MSB 01 01 01 01 01 01 01 01 14 15 16 17 18 19 1A 1C 1D 1E 1F NRPN LSB 08 09 0A 20 21 63 64 66 rr rr rr rr rr rr rr rr rr rr rr PARAMETER Vibrato Rate Vibrato Depth Vibrato Delay Filter Cutoff Frequency Filter Resonance EG Attack Time EG Decay Time EG Release Time Drum Filter Cutoff Frequency Drum Filter Resonance Drum EG Attack Rate Drum EG Decay Rate Drum Instrument Pitch Coarse Drum Instrument Pitch Fine Drum Instrument Level Drum Instrument Panpot Drum Instrument Reverb Send Level Drum Instrument Chorus Send Level Drum Instrument Variation Send Level *rr=Note number for each drum voice instrument.