ZyXEL EOC350-TS User Guide - Page 40
Testing from a Termination Adapter
View all ZyXEL EOC350-TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Chapter 5 EP Management Figure 33 Management > Ether > Config > Status (termination adapter) The following table describes the items in this screen. Table 30 Management > Ether > Config > Status (termination adapter) LABEL DESCRIPTION Status Link This shows whether the port is up or down. Speed/Duplex This shows the speed and the duplex mode of the Ethernet connection on this port. Flow Control This shows whether flow control is enabled on this port. Statistics CLEAR Click this to clear the port traffic statistics. RxPkt This shows how many packets have been received by this port. RxByte This shows how many bytes have been received by this port. TxPkt This shows how many packets have been sent from this port. TxByte This shows how many bytes have been sent from this port. Collision This shows how many Ethernet collisions have been detected on this port. Error This shows how many errors have been detected on this port. Refresh Back Click this to refresh this screen. Click Back to return to the main EP Management screen. 5.9 Testing from a Termination Adapter This section describes the screens used to start diagnostic tests from a termination adapter. 5.9.1 Noise Follow these steps to measure the noise spectrum at the termination adapter's coax interface. 40 EOC350 Series User's Guide