ZyXEL GS1920 Series User Guide - Page 160

Chapter 21 Policy Rule Table 68 Advanced Application > Policy Rule (continued) LABEL Bandwidth Action DESCRIPTION Specify the bandwidth in kilobit per second (Kbps). Enter a number between 64 and 1000000. Specify the action(s) the Switch takes on the associated classified traffic flow. Note: You can specify only one action (pair) in a policy rule. To have the Switch take multiple actions on the same traffic flow, you need to define multiple classifiers with the same criteria and apply different policy rules. Say you have several classifiers that identify the same traffic flow and you specify a different policy rule for each. If their policy actions conflict (Discard the packet, Send the packet to the egress port and Rate Limit), the Switch only applies the policy rules with the Discard the packet and Send the packet to the egress port actions depending on the classifier names. The longer the classifier name, the higher the classifier priority. If two classifier names are the same length, the bigger the character, the higher the classifier priority. The lowercase letters (such as a and b) have higher priority than the capitals (such as A and B) in the classifier name. For example, the classifier with the name of class 2, class a or class B takes priority over the classifier with the name of class 1 or class A. Let's say you set two classifiers (Class 1 and Class 2) and both identify all traffic from MAC address 11:22:33:44:55:66 on port 3. If Policy 1 applies to Class 1 and the action is to drop the packets, Policy 2 applies to Class 2 and the action is to foward the packets to the egress port, the Switch will forward the packets. If Policy 1 applies to Class 1 and the action is to drop the packets, Policy 2 applies to Class 2 and the action is to enable bandwidth limitation, the Switch will discard the packets immediately. If Policy 1 applies to Class 1 and the action is to foward the packets to the egress port, Policy 2 applies to Class 2 and the action is to enable bandwidth limitation, the Switch will forward the packets. Forwarding Select No change to forward the packets. Priority Select Discard the packet to drop the packets. Select No change to keep the priority setting of the frames. Outgoing Select Set the packet's 802.1 priority to replace the packet's 802.1 priority field with the value you set in the Priority field. Select Send the packet to the egress port to send the packet to the egress port. Rate Limit Add Cancel Clear Index Active Name Classifier(s) Delete Delete Cancel Select Set the packet's VLAN ID to replace the VLAN ID of the packets with the value you configure in the VLAN ID field. Select Enable to activate bandwidth limitation on the traffic flow(s). Click Add to inset the entry to the summary table below and save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to reset the fields back to your previous configuration. Click Clear to set the above fields back to the factory defaults. This field displays the policy index number. Click an index number to edit the policy. This field displays Yes when policy is activated and No when is it deactivated. This field displays the name you have assigned to this policy. This field displays the name(s) of the classifier to which this policy applies. Click Delete to remove the selected entry from the summary table. Click Cancel to clear the Delete check boxes. This field displays the policy index number. Click an index number to edit the policy. GS1920 Series User's Guide 160