ZyXEL GS1920 Series User Guide - Page 247

Chapter 30 Private VLAN Figure 181 Advanced Application > Private VLAN The following table describes the labels in this screen. Table 117 Advanced Application > Private VLAN LABEL DESCRIPTION Active Check this box to enable private VLAN in a VLAN. Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes. VLAN ID Enter a VLAN ID from 1 to 4094. This is the VLAN to which this rule applies. Promiscuous Ports Enter the number of the port(s) that can communicate with any ports in the same VLAN. Other ports belonging to this VLAN will be added to the isolation list and can only send and receive traffic from the port(s) you specify here. Add Click Add to insert the entry in the summary table below and save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Cancel Click Cancel to reset the fields to your previous configuration. Clear Click Clear to clear the fields to the factory defaults. Index This is the index number of the rule. Active This shows whether this rule is activated or not. Name This is the descriptive name for this rule. VLAN This is the VLAN to which this rule is applied. Promiscuous Ports This shows the port(s) that can communicate with any ports in the same VLAN. Delete Check the rule(s) that you want to remove in the Delete column and then click the Delete button. Cancel Click Cancel to clear the Delete check boxes. GS1920 Series User's Guide 247