ZyXEL GS1920 Series User Guide - Page 185

Chapter 23 Multicast Table 81 Advanced Application > Multicast > Multicast Setting > MVR (continued) LABEL None Tagging Add DESCRIPTION Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent or received on this port. Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames transmitted. Click this to create a new entry or to update an existing one. Cancel VLAN Active Name Mode Source Port Receiver Port 802.1p Delete Cancel This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. This field displays the multicast VLAN ID. Click on an index number to change the settings. This field displays whether the multicast group is enabled or not. This field displays the descriptive name for this setting. This field displays the MVR mode. This field displays the source port number(s). This field displays the receiver port number(s). This field displays the priority level. To delete a multicast VLAN(s), select the rule(s) that you want to remove in the Delete column, then click the Delete button. Click Cancel to clear the Delete check boxes. 23.6.1 MVR Group Configuration All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this multicast group. Use this screen to configure MVR IP multicast group address(es). Click the Group Configuration link in the MVR screen. Note: A port can belong to more than one multicast VLAN. However, IP multicast group addresses in different multicast VLANs cannot overlap. GS1920 Series User's Guide 185