ZyXEL GS1920 Series User Guide - Page 311
Enabling/Disabling Sending of SNMP Traps on
View all ZyXEL GS1920 Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 311 highlights
Chapter 38 Access Control The following table describes the labels in this screen. Table 154 Management > Access Control > SNMP > Trap Group LABEL Trap Destination IP DESCRIPTION Select one of your configured trap destination IP addresses. These are the IP addresses of the SNMP managers. You must first configure a trap destination IP address in the SNMP Setting screen. Type Options Use the rest of the screen to select which traps the Switch sends to that SNMP manager. Select the categories of SNMP traps that the Switch is to send to the SNMP manager. Select the individual SNMP traps that the Switch is to send to the SNMP station. See SNMP Traps on page 319 for individual trap descriptions. Apply Cancel The traps are grouped by category. Selecting a category automatically selects all of the category's traps. Clear the check boxes for individual traps that you do not want the Switch to send to the SNMP station. Clearing a category's check box automatically clears all of the category's trap check boxes (the Switch only sends traps from selected categories). Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 38.3.2 Enabling/Disabling Sending of SNMP Traps on a Port From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to set whether a trap received on the port(s) would be sent to the SNMP manager. Figure 229 Management > Access Control > SNMP > Trap Group > Port GS1920 Series User's Guide 311