ZyXEL MAX218M2W User Guide - Page 148
VPN, NAT, and NAT Traversal, 8.12.7 ID Type and Content, Table 62, SECURITY PROTOCOL
View all ZyXEL MAX218M2W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Chapter 8 Security 8.12.6 VPN, NAT, and NAT Traversal NAT is incompatible with the AH protocol in both transport and tunnel mode. An IPSec VPN using the AH protocol digitally signs the outbound packet, both data payload and headers, with a hash value appended to the packet, but a NAT device between the IPSec endpoints rewrites the source or destination address. As a result, the VPN device at the receiving end finds a mismatch between the hash value and the data and assumes that the data has been maliciously altered. NAT is not normally compatible with ESP in transport mode either, but the WiMAX Device's NAT Traversal feature provides a way to handle this. NAT traversal allows you to set up an IKE SA when there are NAT routers between the two IPSec routers. Figure 83 NAT Router Between IPSec Routers A B Normally you cannot set up an IKE SA with a NAT router between the two IPSec routers because the NAT router changes the header of the IPSec packet. NAT traversal solves the problem by adding a UDP port 500 header to the IPSec packet. The NAT router forwards the IPSec packet with the UDP port 500 header unchanged. In the above figure, when IPSec router A tries to establish an IKE SA, IPSec router B checks the UDP port 500 header, and IPSec routers A and B build the IKE SA. For NAT traversal to work, you must: • Use ESP security protocol (in either transport or tunnel mode). • Use IKE keying mode. • Enable NAT traversal on both IPSec endpoints. • Set the NAT router to forward UDP port 500 to IPSec router A. Finally, NAT is compatible with ESP in tunnel mode because integrity checks are performed over the combination of the "original header plus original payload," which is unchanged by a NAT device. The compatibility of AH and ESP with NAT in tunnel and transport modes is summarized in the following table. Table 62 VPN and NAT SECURITY PROTOCOL AH AH ESP ESP MODE Transport Tunnel Transport Tunnel NAT N N Y* Y Y* - This is supported in the WiMAX Device if you enable NAT traversal. 8.12.7 ID Type and Content With aggressive negotiation mode (see Section 8.12.4 on page 147), the WiMAX Device identifies incoming SAs by ID type and content since this identifying information is not encrypted. This 148 WiMAX Device Configuration User's Guide