ZyXEL MES-3728 User Guide - Page 259
ARP Inspection VLAN Con
View all ZyXEL MES-3728 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 259 highlights
Chapter 26 IP Source Guard Table 84 ARP Inspection Port Configure (continued) LABEL DESCRIPTION Burst interval (seconds) The burst interval is the length of time over which the rate of ARP packets is monitored for each port. For example, if the Rate is 15 pps and the burst interval is 1 second, then the Switch accepts a maximum of 15 ARP packets in every one-second interval. If the burst interval is 5 seconds, then the Switch accepts a maximum of 75 ARP packets in every five-second interval. Apply Cancel Enter the length (1-15 seconds) of the burst interval. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click this to reset the values in this screen to their last-saved values. 26.7.2 ARP Inspection VLAN Configure Use this screen to enable ARP inspection on each VLAN and to specify when the Switch generates log messages for receiving ARP packets from each VLAN. To open this screen, click Advanced Application > IP Source Guard > ARP Inspection > Configure > VLAN. Figure 133 ARP Inspection VLAN Configure The following table describes the labels in this screen. Table 85 ARP Inspection VLAN Configure LABEL DESCRIPTION VLAN Use this section to specify the VLANs you want to manage in the section below. Start VID Enter the lowest VLAN ID you want to manage in the section below. MES-3728 User's Guide 259