ZyXEL MES-3728 User Guide - Page 260
ARP Inspection VLAN Con continued
View all ZyXEL MES-3728 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
Chapter 26 IP Source Guard Table 85 ARP Inspection VLAN Configure (continued) LABEL DESCRIPTION End VID Enter the highest VLAN ID you want to manage in the section below. Apply Click this to display the specified range of VLANs in the section below. VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure the * VLAN, the settings are applied to all VLANs. Enabled Select Yes to enable ARP inspection on the VLAN. Select No to disable ARP inspection on the VLAN. Log Specify when the Switch generates log messages for receiving ARP packets from the VLAN. None: The Switch does not generate any log messages when it receives an ARP packet from the VLAN. Deny: The Switch generates log messages when it discards an ARP packet from the VLAN. Permit: The Switch generates log messages when it forwards an ARP packet from the VLAN. Apply Cancel All: The Switch generates log messages every time it receives an ARP packet from the VLAN. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click this to reset the values in this screen to their last-saved values. 260 MES-3728 User's Guide