ZyXEL NBG4604 User Guide - Page 104
Network > WAN > Internet Connection: PPTP Encapsulation
View all ZyXEL NBG4604 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Chapter 7 WAN Table 41 Network > WAN > Internet Connection: PPTP Encapsulation LABEL DESCRIPTION Password Type the password associated with the User Name above. Retype to Confirm Type your password again to make sure that you have entered is correctly. Nailed-up Connection Select Nailed-Up Connection if you do not want the connection to time out. Idle Timeout This value specifies the time in minutes that elapses before the NBG4604 automatically disconnects from the PPTP server. PPTP Configuration Server IP Address/ Type the IP address of the PPTP server. Domain Connection ID/ Name Type your identification name for the PPTP server. Get automatically from ISP Select this option If your ISP did not assign you a fixed IP address. This is the default selection. Use Fixed IP Address Select this option If the ISP assigned a fixed IP address. My WAN IP Address Enter your WAN IP address in this field if you selected Use Fixed IP Address. My IP Subnet Mask Your NBG4604 will automatically calculate the subnet mask based on the IP address that you assign. Unless you are implementing subnetting, use the subnet mask computed by the NBG4604. WAN IP Address Assignment Get automatically from ISP Select this to get your WAN IP address from your ISP. DNS Servers First DNS Server Second DNS Server Select From ISP if your ISP dynamically assigns DNS server information (and the NBG4604's WAN IP address). The field to the right displays the (read-only) DNS server IP address that the ISP assigns. Select User-Defined if you have the IP address of a DNS server. Enter the DNS server's IP address in the field to the right. If you chose User-Defined, but leave the IP address set to 0.0.0.0, UserDefined changes to None after you click Apply. If you set a second choice to User-Defined, and enter the same IP address, the second User-Defined changes to None after you click Apply. WAN MAC Address Factory default Select None if you do not want to configure DNS servers. If you do not configure a DNS server, you must know the IP address of a computer in order to access it. The MAC address section allows users to configure the WAN port's MAC address by either using the NBG4604's MAC address, copying the MAC address from a computer on your LAN or manually entering a MAC address. Select Factory default to use the factory assigned default MAC Address. 104 NBG4604 User's Guide