ZyXEL NBG4615 v2 User Guide - Page 17
Table 1, Color, Status, Description
View all ZyXEL NBG4615 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 1 Introduction 1 Make sure the power LED is on (not blinking). 2 Press the WPS button for more than three seconds and release it. Press the WPS button on another WPS-enabled device within range of the NBG4615 v2. Note: You must activate WPS in the NBG4615 v2 that acts as the AP and in another wireless device within two minutes of each other. For more information on using WPS, see Section 12.2 on page 97. 1.7 LEDs Figure 1 Front Panel Power WAN LAN 1-4 WPS WLAN USB The following table describes the LEDs. Table 1 Front panel LEDs LED Power COLOR Green Off WAN Green Off STATUS On On Blinking DESCRIPTION The NBG4615 v2 is receiving power and functioning properly. The NBG4615 v2 is not receiving power. The NBG4615 v2's WAN connection is ready. The NBG4615 v2 is sending/receiving data through the WAN. The WAN connection is not ready, or has failed. NBG4615 v2 User's Guide 17