ZyXEL NBG4615 v2 User Guide - Page 18
Wall Mounting
View all ZyXEL NBG4615 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Chapter 1 Introduction Table 1 Front panel LEDs (continued) LED COLOR STATUS LAN 1-4 Green On Blinking Off WLAN Green On Blinking WPS Off Green On Blinking USB Off Green On Off DESCRIPTION The NBG4615 v2's LAN connection is ready. The NBG4615 v2 is sending/receiving data through the LAN. The LAN connection is not ready, or has failed. The NBG4615 v2 is ready, but is not sending/receiving data through the wireless LAN. The NBG4615 v2 is sending/receiving data through the wireless LAN. The wireless LAN is not ready or has failed. WPS is enabled. The NBG4615 v2 is negotiating a WPS connection with a wireless client. WPS is disabled. The NBG4615 v2 has a USB device installed. There is no USB device connected to the NBG4615 v2. 1.8 Wall Mounting You may need screw anchors if mounting on a concrete or brick wall. Table 2 Wall Mounting Information Distance between holes M4 Screws Screw anchors (optional) 12 cm Two Two 1 Select a position free of obstructions on a wall strong enough to hold the weight of the device. 2 Mark two holes on the wall at the appropriate distance apart for the screws. Be careful to avoid damaging pipes or cables located inside the wall when drilling holes for the screws. 3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave a small gap of about 0.5 cm. If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all the way in - leave a gap of about 0.5 cm. 4 Make sure the screws are fastened well enough to hold the weight of the NBG4615 v2 with the connection cables. 5 Align the holes on the back of the NBG4615 v2 with the screws on the wall. Hang the NBG4615 v2 on the screws. 18 NBG4615 v2 User's Guide