ZyXEL NWA5301-NJ User Guide - Page 34
can cause the firmware to become corrupt.
View all ZyXEL NWA5301-NJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Chapter 1 Introduction Always use Maintenance > Shutdown or the shutdown command before you turn off the NWA/WAC or remove the power. Not doing so can cause the firmware to become corrupt. Table 14 Starting and Stopping the NWA/WAC METHOD DESCRIPTION Turning on the power A cold start occurs when you turn on the power to the NWA/WAC. The NWA/WAC powers up, checks the hardware, and starts the system processes. Rebooting the NWA/ WAC A warm start (without powering down and powering up again) occurs when you use the Reboot button in the Reboot screen or when you use the reboot command. The NWA/ WAC writes all cached data to the local storage, stops the system processes, and then does a warm start. Using the RESET button If you press the RESET button on the back of the NWA/WAC, the NWA/WAC sets the configuration to its default values and then reboots. See Section 22.6 on page 212 for more information. Clicking Maintenance > Shutdown > Shutdown or using the shutdown command Clicking Maintenance > Shutdown > Shutdown or using the shutdown command writes all cached data to the local storage and stops the system processes. Wait for the device to shut down and then manually turn off or remove the power. It does not turn off the power. Disconnecting the power Power off occurs when you turn off the power to the NWA/WAC. The NWA/WAC simply turns off. It does not stop the system processes or write cached data to local storage. The NWA/WAC does not stop or start the system processes when you apply configuration files or run shell scripts although you may temporarily lose access to network resources. NWA / WAC Series User's Guide 34