ZyXEL P-660HN-T1A Support Guide - Page 75

P-660HN Series Support Notes ip policyrouting set criteria packetlength 0 (Set the packet length as 0 for the rule) ip policyrouting set criteria srcip 192.168.1.2 192.168.1.20 (Set the source IP address for the rule: Start=192.168.1.2, end=192.168.1.20) ip policyrouting set criteria srcport 0 (Set the source port for the rule: Start=0) ip policyrouting set criteria destip 0.0.0.0 (Set the destination port for the rule: Start=0.0.0.0) ip policyrouting set criteria destport 80 80 (Set the destination port for the rule: Start=80, end=80) ip policyrouting set action actmatched (Set the action for the rule: Matched) ip policyrouting set action gatewaytype 0 (Set gateway type for the rule: Gateway Address) ip policyrouting set action gatewayaddr 192.168.1.254 (Set the gateway address for the rule: 192.168.1.254) ip policyrouting set criteria serviceType 0 (Set the action type of service as don‟t care for this rule) ip policyrouting set criteria precedence 8 (Set the action precedence as don‟t care for this rule) ip policyrouting set action log no (Set log option for the rule: no log) ip polictrouting set save (Save the rule) Step 3: Apply the IP policy routing. There are two interfaces to apply the policy set, they are the LAN interface and WAN interface. It depends where the gateway specified in the policy rule is located. If the gateway you specified is located on the local LAN you apply the policy set in LAN interface. If the gateway you specified is located on the remote WAN site you apply the policy set in WAN interface. Apply to WAN Interface (Suppose we apply it to remote node 1 in the example): wan node index 1 wan node ippolicy 1 12. Using Call Scheduling  What is Call Scheduling? Call scheduling enables the mechanism for the P-660HN-T1A to run the remote node connection according to the pre-defined schedule. This feature is 75 All contents copyright © 2010 ZyXEL Communications Corporation.