ZyXEL P-660HN-T1A Support Guide - Page 83

P-660HN Series Support Notes  Apply to LAN Interface: lan index [index#] Usage: index#=1 main LAN 2 IP Alias#1 3 IP Alias#2 lan filter Usage: You can apply at most four filter sets to LAN Interface. lan save (3) If you are very advanced user, you could edit filter set by the following command: sys filter set [set#] [rule#] Usage: Set up a filter set index to edit a set. set#: 1~12 rule#: 1~6 sys filter set type [typeID] Usage: typeID: tcpip or generic. Note: In one filter set, you should configure all the rules in one type: either tcpip or generic. sys filter set enable Usage: Enable(active) the rule. sys filter set ......(You could configure a filter rule on demand, the newest command is available on release note) sys filter set save Usage: Don‟t forget to save the rule everytime you‟ve configured it. Reference Commands: sys filter set index [set#] [rule#] sys filter set name [set name] sys filter set type [tcpip | generic] sys filter set enable sys filter set disable sys filter set protocol [protocol #] sys filter set sourceroute [yes|no] sys filter set destip [address] [subnet Set the index of filter set rule, you must apply this command first before you begin to configure the filter rules Set the name of filter set Set the type of filter rule Enable the rule Disable the rule Set the protocol ID of the rule Set the sourceroute yes/no Set the destination IP address and subnet mask of 83 All contents copyright © 2010 ZyXEL Communications Corporation.