2009 BMW 5 Series Owner's Manual - Page 124
2009 BMW 5 Series Manual
Page 124 highlights
Practical interior accessories You can operate the device when the engine is running or when the ignition is switched on. If the device fails to function even after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions for the original hand-held transmitter or hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at Alternating-code hand-held transmitters.< If you have any additional questions, please contact your BMW center.< Deleting all stored programs Press the left and right-hand memory button 1 for approx. 20 seconds until the LED 2 flashes quickly: All stored programs are deleted. Individual programs cannot be deleted. Rememorizing individual programs 1. Hold the original handheld remote control approx. 4 in/10 cm to 12 in/30 cm away from the memory buttons 1. The required distance between the hand-held transmitter and the memory buttons 1 depends on the relevant system of the original hand-held transmitter used.< 2. Press the desired memory button 1 of the integrated universal remote. 3. If the LED 2 flashes slowly after approx. 20 seconds, press the command button of the original hand-held transmitter. As soon as the LED 2 flashes rapidly, release both buttons. If the LED 2 does not flash rapidly after approx. 15 seconds, alter the distance and repeat the step. Alternating-code hand-held transmitters To program the integrated universal remote control, consult the operating instructions for the equipment to be set. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled device. 2. Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters. 3. Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4. Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for step 5. 5. Press the programmed memory button 1 of the integrated universal remote control three times. The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. 122 Sun blinds* Sun blind for rear window Press the button on the driver's door. Online Edition for Part no. 01 41 2 600 721 - © 08/08 BMW AG