1995 Chevrolet S10 Pickup Owner's Manual - Page 129
1995 Chevrolet S10 Pickup Manual
Page 129 highlights
To Lock The System: 1. Write down any 6 digit number and keep it in a safe place. 2. Turn the ignition to the ACC (Accessory) or RUN position. 3. Press the PWR knob to turn the radio off. 4. Press the 1 and 4 buttons together. Hold them down until shows on the display. You are now ready to enter your secret code. Don't wait more than 15 seconds between steps. 5. Press SET and "000" will appear on the display. 6. Press the SEEK or 4 button to make the first number appear. 7. Press SCAN to make the next two numbers agree with your code. 8. Press BAND and "000" will appear again. Now you are ready to enter the last three digits of your code. 9. Repeat steps 6 and 7 for the last three digits of your code. 10. Press BAND and "rEP' will appear for 5 seconds and then "OOO" will appear. 11. Repeat steps 6 through 10. This time "SEC" will appear - indicating that the radio is secure. To Unlock The System After A Power Loss When battery power is reapplied to a secured radio, the radio won't turn on and "LOC" will appear on the display. Enter your secret code as follows. Pause no more than 15 seconds between steps. 1. Turn the ignition on. (Radio off.) 2. Press the SET button. The display will show "000". 3. Enter the six digits of the code following steps 6-9 above. The display will show the numbers as entered. 4. Press the BAND knob and the time appears - indicating that the disabling sequence was successful. If the display indicates "SEC", the numbers did not match and the unit is still secured. 3-16