1995 Chevrolet S10 Pickup Owner's Manual - Page 266

Using Foam-Type Cleaner on Fabric Vacuum and brush the area to remove any loose dirt. Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. 0 Mix Multi-Purpose Powdered Cleaner following the directions on the container label. Use suds only and apply with a clean sponge. Don't saturate the material. Don't rub it roughly. As soon as you've cleaned thesection, use a sponge toremove the suds. 0 0 Rinse the sectionwith a clean, wet sponge. Wipe off what's left with a slightly damp paper towel or cloth. Then dry it immediately with a blow dryer or a heat lamp. I NOTICE: Be careful. A blow dryer may scorch the fabric. 0 Wipe with a clean cloth. Using Solvent-Type Cleaner on Fabric First, see if you have to use solvent-type cleaner at all. Some spotsand stains will clean off better with just water and mild soap. If you need to use a solvent: Gently scrape excesssoil from the trim material with a clean, dull knife or scraper. Use very little cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning should start at the outsideof the stain, "feathering" toward the center. Keep changing to a cleansection of the cloth. 0 When you clean a stain from fabric, immediately dry the area with a blow dryer to help prevent a cleaning ring. (See the previous NOTICE.) 6-49