2014 Chevrolet Spark Owner Manual - Page 26

2-4 Keys, Doors, and Windows Programming with a Recognized Transmitter To program a new key: 1. Insert the original, already programmed key in the ignition and turn the key to the ON/RUN position. 2. Turn the key to LOCK/OFF, and remove the key. 3. Insert the new key to be programmed and turn it to the ON/RUN position within five seconds. The security light will turn off once the key has been programmed. 4. Repeat Steps 1-3 if additional keys are to be programmed. If a key is lost or damaged, see your dealer to have a new key made. Programming without a Recognized Transmitter Program a new key to the vehicle when a recognized key is not available. Canadian regulations require that owners see their dealer. If there are no currently recognized keys available, follow this procedure to program the first key. This procedure will take approximately 30 minutes to complete for the first key. The vehicle must be off and all of the keys you wish to program must be with you. 1. Insert the new vehicle key into the ignition. 2. Turn to ON/RUN. The security light will come on. 3. Wait 10 minutes until the security light turns off. 4. Turn the ignition to LOCK/OFF. exterior lamps flash and the horn chirps three times. Press and hold 7 for at least three seconds to sound the panic alarm. The horn sounds and the turn signals flash for 30 seconds, or until 7 is pressed again, or the key is placed in the ignition and turned to ON/RUN. Programming Transmitters to the Vehicle Only RKE transmitters programmed to this vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer. When the replacement transmitter is programmed to this vehicle, all remaining transmitters must also be reprogrammed. Any lost or stolen transmitters will no longer work once the new transmitter is programmed. See your dealer to have new transmitters programmed.