2014 Chevrolet Spark Owner Manual - Page 97

Instruments and Controls 5-3 Windshield Wiper/Washer INT (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then turn the x INT band up for more frequent wipes or down for less frequent wipes. OFF: Use to turn the wipers off. If the windshield wiper lever is then moved to off before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield. If the ignition is turned to LOCK/ OFF while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield. 8 (Mist): The windshield wiper/washer lever is on the right side of the steering column. Move the lever to one of the following positions: HI: Use for fast wipes. LO: Use for slow wipes. For a single wipe, briefly move the wiper lever down. For several wipes, hold the wiper lever down. Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Replace damaged wiper blades. See Wiper Blade Replacement on page 10-23. Heavy snow or ice can overload the wiper motor. A circuit breaker will stop the motor until it cools down. Wiper Parking If the ignition is turned to LOCK/ OFF while the wipers are on LO, HI, or INT, they will immediately stop. Windshield Washer Pull the windshield wiper lever toward you to spray windshield washer fluid and activate the wipers. The wipers will continue until the lever is released or the maximum wash time is reached. When the windshield wiper lever is released, additional wipes may occur depending on how long the windshield washer had been activated. See Washer Fluid on page 10-18 for information on filling the windshield washer fluid reservoir.