2005 Chrysler Crossfire Owner Manual SRT6 - Page 103
2005 Chrysler Crossfire Manual
Page 103 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 103 14. Seat Belt Indicator Light With the key in the ignition, the light comes on, and a warning sounds for a short time if the driver's seat belt is not fastened. After starting the engine, the seat belt indicator light blinks and a chime sounds periodically for up to 90 seconds to remind the driver and passenger to fasten the seat belts. Fastening the seat belts will extinguish the light and silence the chime. The seat belt indicator light will remain lit until the seat belts are fastened. 15. Charging System Indicator Light Should the charging system indicator light fail to come on prior to starting when the key is in the ignition switch in the ON/RUN position, or should it fail to go out after starting or during operation, it indicates a malfunction that must be repaired immediately at an authorized dealer. If the charging system indicator light comes on, or a loss of power steering assistance is noticeable while the engine is running, this may indicate that the accessory drive belt has broken. Should this condition occur, the belt must be replaced before continuing to operate the vehicle. CAUTION! The accessory drive belt also drives the water pump. Operating the vehicle with a failed belt can cause engine overheating and possible severe engine damage. 16. High Beam Indicator Light This indicator will illuminate when the headlights are in the high beam setting. 4 To activate the high beams, push the multifunction control lever past the point of resistance, toward the instrument panel.