2005 Chrysler Crossfire Owner Manual SRT6 - Page 91

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 91 NOTE: Step 3 does not have to be followed to program additional hand-held transmitters. 4. Choose one of the three buttons to program. Place the hand-held controller 1-3 inches (25-76 mm) from the universal transceiver while keeping its indicator light in view. NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 5 with procedures noted in the "Gate Operator/Canadian Programming" section. 6. The indicator light in the universal transceiver will begin to flash, first slowly and then rapidly. Release both buttons after the indicator light changes from slow to rapid flash. If, after 90 seconds, the indicator does not flash rapidly or goes out, return to Step 1 and repeat the procedure. 7. Press and hold the just programmed universal transceiver button and observe the indicator light. If the indicator stays on constantly, programming is complete and your device should activate when the universal transceiver button is pressed and released. NOTE: To program the remaining two universal transceiver buttons, begin with Programming Step 4. Do not repeat Steps 1, 2, and 3. If the indicator light blinks rapidly for two seconds and then turns to a constant light, continue with 3 5. Using both hands, press the hand-held transmitter button and the desired universal transceiver button. Do not release the buttons until Step 6 has been completed.