2005 Chrysler Crossfire Owner Manual SRT6 - Page 93
2005 Chrysler Crossfire Manual
Page 93 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 93 signal has successfully been accepted by the universal transmitter. (The indicator light will flash slowly and then rapidly.) Proceed with Programming Step 6 to complete. Using the Universal Transceiver To operate the universal transceiver, simply press and release the programmed button. Activation will now occur for the programmed device (i.e. garage door opener, gate operator, security system, entry door lock, home/ office lighting, etc.) For convenience, the hand-held transmitter of the device may also be used at any time. Erasing Universal Transceiver Buttons To erase programming from the three buttons (individual buttons cannot be erased but can be reprogrammed - see below), follow this procedure: • Press and hold the two outer universal transceiver buttons until the indicator light begins to flash after 20 seconds. Release both buttons. Do not hold for longer than 30 seconds. The universal transceiver is now in the program (or learning) mode and can be programmed at any time beginning with Programming Step 4. Reprogramming a Single Button To program a device using a universal transceiver button previously programmed, follow these steps: 1. Press and hold the desired universal transceiver button. DO NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the universal transceiver button, proceed with Programming Step 4. Security If you sell your vehicle, be sure to erase the frequencies. To erase all of the previously programmed frequencies, hold down both outside buttons until the light begins to flash. This device complies with part 15 of FCC rules and with RS-210 of Industry Canada. Operation is subject to the following conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference that may be received, including interference that may cause undesired operation. 3