2005 Chrysler Crossfire Owner Manual SRT6 - Page 54

54 UNDERSTANDING THE FEATURES OF YOUR VEHICLE CAUTION! To avoid possible damage to the tonneau cover and convertible top, do not allow the convertible top to remain in the suspended position. After approximately 10 minutes in the suspended position an audible beep will be heard and the hydraulic pressure will be released which will allow the top and the tonneau cover to lower. The convertible top switch can be pressed to cancel this operation. CAUTION! To fully insure that no damage occurs, be sure that the vehicle is at a complete stop before attempting to lower or raise the top. NOTE: If the top does not operate or stops during the raising or lowering procedure, start the engine and continue operation. 1. Make sure the rear cargo compartment divider is unfolded and secured in the vertical position. A slow audible information signal will be heard and the convertible top switch lamp will flash slowly if the cargo compartment divider is not in the vertical position. If the divider is in its stowed position, first unfold the panels towards the rear of the vehicle. Pull up on the vertical panel using the center cutout shown, and hook the pins at the top into the brackets mounted to the cargo compartment trim on each side near the forward edge of the decklid opening. The pins must be hooked in these brackets in order for the top to operate. NOTE: See label attached to underside of decklid. CAUTION! To avoid damage to either the top or the rear window, check the tonneau cover area at the rear of the vehicle interior to be sure that it is clear of debris or other items. Do not use the tonneau cover area for other storage purposes.