2005 Chrysler Crossfire Owner Manual SRT6 - Page 85
2005 Chrysler Crossfire Manual
Page 85 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85 If the ESP warning light begins to flash during acceleration, ease up on the accelerator and apply as little throttle as possible. Be sure to adapt your speed and driving to the prevailing road conditions. When the ESP warning light is illuminated continuously, the ESP is switched off. To return to the enhanced vehicle stability offered by ESP, press the lower half of the switch (the ESP warning light in the speedometer dial goes out). Avoid spinning one drive wheel. This may cause serious damage to the drive train and is not covered by the DaimlerChrysler warranty. Synchronizing ESP If the power supply was interrupted (battery disconnected or discharged), the BAS/ESP malfunction indicator light may be illuminated with the engine running. To re-synchronize the ESP, and cancel the malfunction indicator light, the steering angle sensor will need to be recalibrated. 1. Turn the ignition switch to the ON/RUN position. 2. Rotate the steering wheel to the center position. 3. Rotate the steering wheel completely to the left, and then rotate the steering wheel completely to the right. 4. Bring the steering wheel back to the center position. 5. The BAS/ESP malfunction indicator light will go out. If the BAS/ESP malfunction indicator light is still illuminated, the vehicle should be serviced at an authorized dealer. 3 CAUTION! If the vehicle is towed with the front axle raised, the engine must be shut off (key in the ignition switch to the OFF/LOCK or ACC position). Otherwise the ESP will immediately be engaged and will apply the rear wheel brakes.