2009 Chrysler Town & Country Owner Manual - Page 211

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 209 Programming HomeLinkா Before You Begin If you have not trained any of the HomeLink௡ buttons, 3. Simultaneously press and hold both the chosen erase all channels before you begin training. HomeLink௡ button and the hand-held transmitter button To do this, press and hold the two outside buttons for up until the HomeLink௡ indicator changes from a slow to a to 20 seconds until the red indicator flashes. rapidly blinking light, then release both the HomeLink௡ It is recommended that a new battery be placed in the and hand-held transmitter buttons. hand-held transmitter of the device being programmed Watch for the HomeLink௡ indicator to change flash rates. to HomeLink௡ for more efficient training and accurate When it changes, it is programmed. It may take up to transmission of the radio-frequency signal. 30 seconds, or longer in rare cases. The garage door may Your vehicle should be parked outside of the garage open and close while you train. when programming. NOTE: Begin Programming • Some gate operators and garage door openers may require you to replace Step 3 with procedures noted in 1. Turn the ignition switch to the ON/RUN position. the "Gate Operator/Canadian Programming" section. 2. Hold the battery side of the hand-held transmitter away from the HomeLink௡ button you wish to program. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink௡ button you wish to program while keeping the indicator light in view. 3