2009 Chrysler Town & Country Owner Manual - Page 266

264 UNDERSTANDING YOUR INSTRUMENT PANEL • Blind Spot System Not Available - This message is displayed to indicate the Blind Spot Monitor (BSM) system is temporarily unavailable due to sensor blockage, electronic interference, or other ЉtemporaryЉ conditions. When this message is displayed both outside rear view icons will be illuminated. If electronic interference is present, the BSM system will illuminate the icon only on the side of interference as long as interference is present. flash in the EVIC display for approximately 10 seconds, after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty-cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and • Service Blind Spot System - This message is dis- release the Menu button. To reset the oil change indicator played to indicate the Blind Spot Monitor (BSM) system (after performing the scheduled maintenance) system is permanently unavailable. The driver will perform the following steps. receive an EVIC message and the BSM display warn1. Turn the ignition switch to the ON position (do not ing in both mirrors will be permanently illuminated. If start the engine). this message is present see an authorized dealer. 2. Fully depress the accelerator pedal, slowly, three times Oil Change Required within 10 seconds. Your vehicle is equipped with an engine oil change indicator system. The Oil Change Required message will 3. Turn the ignition switch to the OFF/LOCK position.