2009 Chrysler Town & Country Owner Manual - Page 486

484 MAINTAINING YOUR VEHICLE WARNING! A transient high voltage occurs at the bulb sockets of High Intensity Discharge (HID) headlamps when the headlamp switch is turned ON. It may cause serious electrical shock or electrocution if not serviced properly. See your authorized dealer for service. 3. Twist the headlamp bulb and pull the bulb from the headlamp housing. 4. Install the new headlamp bulb and twist until locked into the headlamp housing. CAUTION! Do not touch the new bulb with your fingers. Oil NOTE: On vehicles equipped with High Intensity Dis- contamination will severely shorten bulb life. If the charge (HID) headlamps, when the headlamps are bulb comes in contact with an oily surface, clean the turned on, there is a blue hue to the lamps. This dimin- bulb with rubbing alcohol. ishes and becomes more white after approximately 5. Reconnect the wiring connector to the bulb. 10 seconds, as the system charges. Quad Headlamps 1. Raise the hood to access the high or low beam bulbs at the rear of the headlamp housing. Front Park/Turn Signal Lamp 1. Raise the hood to access the rear of the headlamp housing. 2. Release the two tabs on the side of the connector and 2. Twist the turn signal socket and remove from the remove the connector from the bulb. headlamp housing, then pull the bulb out.