2015 Dodge Charger Owner Manual - Page 183

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 181 NOTE: To Vary The Speed Setting • If your vehicle stays at standstill for longer than two To Increase Speed seconds, then the system will cancel and the brake While ACC is set, you can increase the set speed by force will be ramped-out. The driver will have to apply pressing the SET + button. the brakes to keep the vehicle at a standstill. The drivers preferred units can be selected through the • ACC cannot be resumed if there is a stationary vehicle instrument panel settings if equipped. Refer to " Underin-front of your vehicle in close proximity. standing Your Instrument Panel" for more information. The speed increment shown is dependant on the chosen WARNING! speed unit of U.S. (mph) or Metric (km/h): The Resume function should only be used if traffic and road conditions permit. Resuming a set speed that is too high or too low for prevailing traffic and road conditions could cause the vehicle to accelerate or decelerate too sharply for safe operation. Failure to follow these warnings can result in a collision and death or serious personal injury. U.S. Speed (mph) • Pressing the SET + button once will result in a 1 mph increase in set speed. Each subsequent tap of the button results in an increase of 1 mph. • If the button is continually pressed, the set speed will continue to increase in 5 mph increments until the button is released. The increase in set speed is reflected in the DID. 3