2015 Dodge Charger Owner Manual - Page 383

STARTING AND OPERATING 381 4. If you wish to stop the cranking of the engine prior to the engine starting, push the button again. NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. To Turn Off The Engine Using ENGINE START/STOP Button position. If the shift lever/gear selector is not in PARK and the ENGINE START/STOP button is pressed once, the DID will display a "Vehicle Not In Park" message and the engine will remain running. Never leave a vehicle out of the PARK position, or it could roll. NOTE: If the ignition switch is left in the ACC or RUN (engine not running) position and the transmission is in 1. Place the shift lever/gear selector in PARK, then press PARK, the system will automatically time out after 30 and release the ENGINE START/STOP button. minutes of inactivity and the ignition will switch to the OFF position. 2. The ignition switch will return to the OFF position. ENGINE START/STOP Button Functions - With 3. If the shift lever/gear selector is not in PARK, the Driver's Foot OFF The Brake Pedal (In PARK Or ENGINE START/STOP button must be held for two NEUTRAL Position) seconds or three short presses in a row with the vehicle speed above 5 mph (8 km/h) before the engine The ENGINE START/STOP button operates similar to an will shut off. The ignition switch position will remain ignition switch. It has three positions, OFF, ACC, RUN. in the ACC position until the shift lever/gear selector To change the ignition switch positions without starting is in PARK and the button is pressed twice to the OFF the vehicle and use the accessories follow these steps: 5