2015 Dodge Charger Owner Manual - Page 233

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 231 3. Without releasing the button proceed with "Program- 1. Cycle the ignition to the ON/RUN position. ming A Non-Rolling Code" step 2 and follow all 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 remaining steps. cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator Canadian/Gate Operator Programming light in view. For programming transmitters in Canada/United States that require the transmitter signals to "time-out" after 3. Continue to push and hold the HomeLink® button, several seconds of transmission. while you push and release ("cycle") your hand-held transmitter every two seconds until HomeLink® has Canadian radio frequency laws require transmitter sigsuccessfully accepted the frequency signal. The indinals to time-out (or quit) after several seconds of transcator light will flash slowly and then rapidly when mission - which may not be long enough for HomeLink® fully trained. to pick up the signal during programming. Similar to this 3 Canadian law, some U.S. gate operators are designed to 4. Watch for the HomeLink® indicator to change flash time-out in the same manner. rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage It may be helpful to unplug the device during the cycling door may open and close while you are programming. process to prevent possible overheating of the garage door or gate motor. 5. Push and hold the programmed HomeLink® button and observe the indicator light.