2015 Dodge Charger Owner Manual - Page 234

232 UNDERSTANDING THE FEATURES OF YOUR VEHICLE • If the indicator light stays on constantly, program- 3. Without releasing the button proceed with "Canadian/Gate Operator Programming" step 2 and ming is complete and the garage door/device should follow all remaining steps. activate when the HomeLink® button is pushed. • To program the two remaining HomeLink® buttons, Using HomeLink® repeat each step for each remaining button. DO NOT To operate, push and release the programmed erase the channels. HomeLink® button. Activation will now occur for the If you unplugged the garage door opener/device for programmed device (i.e., garage door opener, gate operaprogramming, plug it back in at this time. tor, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may Reprogramming A Single HomeLink® Button also be used at any time. (Canadian/Gate Operator) To reprogram a channel that has been previously trained, Security follow these steps: It is advised to erase all channels before you sell or turn in your vehicle. 1. Cycle the ignition to the ON/RUN position. 2. Push and hold the desired HomeLink® button until To do this, push and hold the two outside buttons for 20 the indicator light begins to flash after 20 seconds. Do seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be not release the button. erased.