2015 Dodge Charger Owner Manual - Page 501

WHAT TO DO IN EMERGENCIES 499 NOTE: Sealant may leak out through the puncture in the NOTE: If the Mode Select Knob (5) is on Air Mode and tire. the pump is operating, air will dispense from the Air If the sealant (white fluid) does not flow within 0 - 10 Pump Hose (7) only, not the Sealant Hose (6). seconds through the Sealant Hose (6): If the sealant (white fluid) does flow through the 1. Press the Power Button (4) to turn Off the Tire Service Sealant Hose (6): Kit. Disconnect the Sealant Hose (6) from the valve 1. Continue to operate the pump until sealant is no stem. Make sure the valve stem is free of debris. longer flowing through hose (typically takes 30 - 70 Reconnect the Sealant Hose (6) to the valve stem. seconds). As the sealant flows through the Sealant Check that the Mode Select Knob (5) is in the Sealant Hose (6), the Pressure Gauge (3) can read as high as 70 Mode position and not Air Mode. Press the Power psi (4.8 Bar). The Pressure Gauge (3) will decrease Button (4) to turn On the Tire Service Kit. quickly from approximately 70 psi (4.8 Bar) to the actual tire pressure when the Sealant Bottle (1) is 2. Connect the Power Plug (8) to a different 12 Volt empty. power outlet in your vehicle or another vehicle, if available. Make sure the engine is running before 2. The pump will start to inject air into the tire immediturning ON the Tire Service Kit. ately after the Sealant Bottle (1) is empty. Continue to operate the pump and inflate the tire to the pressure 3. The Sealant Bottle (1) may be empty due to previous indicated on the tire pressure label on the driver-side use. Call for assistance. 6