2013 Ford C-MAX Hybrid Owner Manual Printing 3 - Page 303

302 Maintenance 1. Make sure the lighting control is in the off position and open the hood. 2. Remove the two screws from the headlamp assembly. 3. Carefully pull the headlamp assembly as far as possible towards the center of the vehicle to disengage it from the lower fixing point. 4. Carefully lift the outer side of the headlamp and remove it. 5. Disconnect the electrical connector. REMOVING A HEADLAMP CHANGING A BULB Lamp Assembly Condensation Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a thin film of mist can form on the interior of the lens. The thin mist eventually clears and exits through the vents during normal operation. Clearing time may take as long as 48 hours under dry weather conditions. These are examples of acceptable condensation: • Presence of thin mist (no streaks, drip marks or droplets). • Fine mist covers less than 50% of the lens. 2013 C-Max Full Hybrid (34h) Owners Guide gf, 3rd Printing, January 2013 USA (fus)