2013 Ford C-MAX Hybrid Owner Manual Printing 3 - Page 346

Wheels and Tires 345 9. When the recommended tire pressure is reached, turn off the kit by pressing the on and off button, then disconnect the kit from the tire valve and the power point. Re-install the valve cap on the tire valve, place the tube cap on the metal connector, and return the kit to the stowage area. 10. Note: Immediately and cautiously, drive the vehicle 4 miles (6 kilometers) to distribute the sealant evenly inside the tire. Do not exceed 50 mph (80 km/h). Note: If you experience any unusual vibration, ride disturbance or noise while driving, reduce your speed until you can safely pull off to the side of the road to call for roadside assistance. Note: Do not proceed to the second stage of this operation. 11. After 4 miles (6 kilometers), stop and check the tire pressure. See Second Stage: Checking Tire Pressure. Second Stage: Checking Tire Pressure WARNING: If you are proceeding from the First Stage: Reinflating the Tire with Sealing Compound and Air section and have injected sealant in the tire and the pressure is below 20 psi (1.4 bar), stop and call roadside assistance. If tire pressure is above 20 psi (1.4 bar), continue to the next step. WARNING: The power plug may get hot after use and should be handled carefully while unplugging. Check the air pressure of your tires as follows: 1. Remove the valve cap from the tire valve. 2. Unhook the black hose from the side of the compressor and fasten firmly on the valve stem by turning clockwise. 3. Press down and turn the dial clockwise to the air position. Turn on the kit by pressing the on/off button. 2013 C-Max Full Hybrid (34h) Owners Guide gf, 3rd Printing, January 2013 USA (fus)